Netgear RH348 Uživatelský manuál stáhnout pdf (Strana 45)

Router Configuration 3-1

Chapter 3

Router Conﬁguration

This chapter contains information about conﬁguring your Model RT328/RH348 router through

the built-in Manager interface.

Conﬁguration Methods

If you are using a PC, you have the following two options to conﬁgure your router:

• Through FirstGear

FirstGear is an easy-to-use Windows-based utility that leads you through a Quick Setup or

an Advanced menu for conﬁguring your router. For FirstGear instructions, refer to

Getting

Started Using FirstGear for the Model RT328 and Model RH348 ISDN Routers

• Through the built-in Manager interface

If you are using a Macintosh or UNIX-based workstation, the built-in Manager interface is the

only way that you can conﬁgure your router through your computer. However, you can use a

PC to conﬁgure the router and then connect the router to the Macintosh or workstation after the

conﬁguration process is complete.

The built-in Manager interface is accessible through either a serial or a Telnet connection (refer to

“Connecting Through a Serial Port” or “Connecting Through a Telnet Connection” on page 2-9,

respectively, of Chapter 2, “Router Installation and Connection”). If the router has not previously

been assigned an IP address, you cannot connect through a Telnet session. You must use a serial

connection.

Config.fm Page 1 Tuesday, October 10, 2000 3:17 PM

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 141 142

Žádné komentáře

Netgear RH348 Uživatelský manuál Strana 45