Netgear Switch L3 Uživatelský manuál stáhnout pdf (Strana 39)

7000 Series L3 Managed Switch Reference Manual for Software v2.0

Command Line Interface Syntax 5-1

Chapter 5

Command Line Interface Syntax

The Command Line Interface (CLI) syntax, conventions and terminology are described in this

section. Each CLI command is illustrated using the structure outlined below.

CLI Command Format

Commands are followed by values, parameters or both.

Example 1: config network parms <ipAddr> <netmask> [gateway]

– config network parms is the command name.

– <ipAddr> <netmask> are the required values for the command.

– [gateway] is the optional value for the command.

Example 2: config syslocation <location>

– config syslocation is the command name.

– <location> is the required parameter for the command.

Example 3: config lag deleteport <logical slot.port> <slot.port|all>

– config lag deleteport is the command name.

– <logical slot.port> <slot.port|all> are the required values for the

command.

• Command: The text in bold, non-italic font must be typed exactly as shown.

• Parameters: Parameters are order dependent.

The text in bold italics should be replaced with a name or number. To use spaces as part of a

name parameter, enclose it in double quotes like this: "System Name with Spaces".

Parameters may be mandatory values, optional values, choices or a combination.

– <parameter>. The <> angle brackets indicate that a mandatory parameter must be entered

in place of the brackets and text inside them.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 270 271

Žádné komentáře

Netgear Switch L3 Uživatelský manuál Strana 39