Netgear WNDAP380Rv2 Uživatelský manuál stáhnout pdf (Strana 22)

Installation and Basic Configuration

ProSAFE Dual Band Wireless-N Access Point with RFID Support, WNDAP380R

Tip: If you enable the DHCP client on the wireless access point, you can

discover the new IP address of the wireless access point by accessing

the DHCP server on your LAN, or by using a network IP address scanner

application.

 To configure the IP settings:

1. Select Configuration > IP > IP Settings.

The IP Settings screen displays:

2. Configure the IP settings as explained in the following table:

Setting Description

DHCP Client By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If

you have a DHCP server on your LAN and you select the Enable radio button,

the wireless access point receives its IP address, subnet mask, and default

gateway settings automatically from the DHCP server on your network when you

connect the wireless access point to your LAN.

IP Address Enter the IP address of your wireless access point. The default IP address is

192.168.0.100.

To change the address, enter an unused IP address from the

address range used on your LAN, or enable DHCP the server

IP Subnet Mask Enter the network number portion of an IP address. Unless you are

implementing subnetting, enter 255.255.0.0 as the subnet mask.

Default Gateway Enter the IP address of the ISP gateway to which the wireless access point

connects.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 151 152

Žádné komentáře

Netgear WNDAP380Rv2 Uživatelský manuál Strana 22